| FAULT CODE |
FAULT CODE DESCRIPTION |
MODEL |
SYMPTOMS |
PROBLEM SOLVING |
REMEDY |
| 10167 |
Output stage to electric fuel pump |
GS/A 1200 |
Idling irregular
Battles to start
Fault appears to start intermittently
Bike may start and ride, then will appear to have fuel starvation |
This unit is situated on the left
side of the tank. It is a little aluminium unit with fins on. Check the o-ring
of this unit. Unscrew the unit and check for moisture in the cavity below it. Use
moisture repellent spray and contact cleaner to clean this device. |
If problem solving does not work
then replace the unit. |
| 10218 |
CAN-Bus Timeout: No communication
with KOMBI (Instrument cluster) control unit |
GS/A 1200 |
|
Test with diagnostic
system. |
Clear fault code. |
| 10219 |
CAN-Bus Timeout: no communication
with ZFE (Central vehicle electronics) control unit |
GS/A 1200 |
Instrument cluster does not activate
properly.
Instrument cluster activates partially and then fades away.
May start on intermittent occasions |
Test with diagnostic
system. |
If all else fails replace the ZFE
control unit. (Very expensive). |
| 10444 |
Fuse activated for component block 3
(starter relay, Immo (EWS) ring aerial, ignition coils, injectors) |
GS/A 1200 |
There may be a short on the battery
terminals or elsewhere. Can happen in conjuction with fault code 10219.
|
Ensure battery voltage is correct.
Tighten battery terminals.
Ensure good connection on batter terminals. |
Clear fault code. |
| 23955 |
Front Wheel Speed
Sensor: Signal implausible. |
GS/A 1200 |
Possible dirt on
sensor. Dirt on wheel where sensor lost contact. |
Test with diagnostic
system |
Clear fault code.
Replace sensor if fault code re-appears. |
| 23971 |
Rear wheel speed sensor: Signal
implausible |
GS/A 1200 |
Possible dirt on
sensor. Dirt on wheel where sensor lost contact. |
Test with diagnostic
system. |
Clear fault code.
Replace sensor if fault code re-appears. |
| 24052 |
Electric System under-voltage |
GS/A 1200 |
Starter motor battles to turn
Instrument cluster fades and then reappears. |
Check Battery Voltage
Check that the alternator is charging battery
Check wiring to see that a short is not draining battery power. |
Replace battery if it is not
charging
or
Service alternator |
| 24971 |
Pressure In Front
Wheel Circuit To High |
GS/A 1200 |
Check Wheel Pressure! |
Release air out of
front wheel to the correct pressure. |
Clear Fault Code |
| 25193 |
Internal Control
Module Error - Time out message ZFE_2 |
GS/A 1200 |
Not sure if there are
any symptoms but the fault code was not present when diagnostics were
performed. |
Fault occurred
possibly due low voltage from the battery at some stage |
Clear Fault Code |
| 25165 |
Internal Control
Module Error - Main processor reset due to under voltage |
GS/A 1200 |
Not sure if there are
any symptoms but the fault code was not present when diagnostics were
performed. |
Fault occurred
possibly due low voltage from the battery at some stage |
Clear Fault Code |
| 25193 |
Brake fluid level to
low |
GS/A 1200 |
Check brake fluid
levels, front and rear reservoirs. |
Test with diagnostic
system. |
Add brake fluid and
clear fault code. |
| 37641 |
Electrical System
(KL30) under voltage |
GS/A 1200 |
Not sure if there are
any symptoms but the fault code was not present when diagnostics were
performed. |
Fault occurred
possibly due low voltage from the battery at some stage |
Clear Fault Code |
| 41722 |
Park Light Open
Circuit |
GS/A 1200 |
Park light could be
faulty |
Check connections are
secure or replace bulb if faulty. |
Clear Fault Code |
| 41724 |
Main High Beam
headlight, open circuit. |
R1200RT |
Main high beam light
could be faulty or have a poor connection. |
Check connections are
secure or replace bulb if faulty. |
Clear Fault Code |
| 41726 |
Low Beam Headlight 1,
open circuit. |
R1200RT |
Low beam headlight
could be faulty or have a poor connection. |
Check connections are
secure or replace bulb if faulty. |
Clear Fault Code |
| 41729 |
Low Beam Headlight 2,
open circuit. |
R1200RT |
Low beam headlight
could be faulty or have a poor connection. |
Check connections are
secure or replace bulb if faulty. |
Clear Fault Code |
| 54104 |
CAN-Bus: No
communication with instrument cluster (Kombi) control unit |
GS/A 1200 |
This fault may occur
in conjunction with a faulty ignition. |
Test with diagnostic
system |
Clear Fault Code. |
| 288 |
Throttle Position
Sensor, Internal Fault on Upper or lower Potentiometer Slider. |
GS/A 1150 |
Rough Idling |
Measure Voltage,
optimum is around 0.36 volts. |
Replace potentiometer
and set at correct voltage. Clear fault code. |
| 821 |
Hall Sensor 1, no
signal - this fault will always occur if engine is not running or engine is
not cranked before reading fault codes. |
GS/A 1150 |
Bike will not run. |
Replace sensor! |
Replace sensor if
fault code cannot be cleared. |
| 901 |
Hall Sensor 2, no
signal - this fault will always occur if engine is not running or engine is
not cranked before reading fault codes. |
GS/A 1150 |
Bike will not run. |
Replace sensor! |
Replace sensor if
fault code cannot be cleared. |
| 17163 |
Front ABS motor
defective. |
R1150RT |
ABS warning light
flashing and no power brake function... residual braking only. Depending
upon whether front brake (lever) applied or rear brake pedal... sometimes
the servo motor would race but no ABS function. |
It would be best to
have your nearest BMW agent confirm your fault code. |
Replace complete ABS
unit, which will be very costly. Clear fault codes. |
| 17433 |
Pressure in rear wheel
cylinder to low. |
R1150RT |
Refer to fault code
17163 for details on symptoms. |
It would be best to
have your nearest BMW agent confirm your fault code. |
Replace complete ABS
unit, which will be very costly. Clear fault codes. |
| 277 |
Engine Coolant
Temperature Sensor Malfunction, Short circuit to earth or temperature too
low. |
GS 650 Dakar |
No coolant in system |
Check coolant system
for leaks. Check all hoses. Check radiator cap. Check water pump seal. |
Replace coolant sensor
if necessary. Clear fault codes. |
| 304 |
Oxygen (Lamda) Sensor
Circuit Malfunction, No signal or signal intermittent. |
GS 650 Dakar |
Symptoms not openly
evident. Bike may be running rich. |
Check and clean
connections on wire harness. |
If fault persists,
check or replace lambda sensor. Clear fault code. |
| 309 |
Oxygen (Lambda) Sensor
Heating Circuit Malfunction, Signal implausible |
GS 650 Dakar |
Irregular engine
operation. Engine will not function properly. |
Test with diagnostic
system. Reading should alternate between 200mV and 650mV. |
Replace Lambda sensor
if necessary. Clear Fault Code. |
| 821 |
Speed Sensor
(rpm) |
GS 650 Dakar |
Irregular speed
reading on instruments. |
Clean sensor.
Make sure the wire is not damaged. |
Replace sensor if
necessary. Clear Fault Code. |
| 1152 |
Cooling Fan Motor,
signal implausible. |
GS 650 Dakar |
Cooling fan does not
work. Cooling fan works intermittently on activation. Will lead to
overheating. |
Test with diagnostic
system whether the fan works |
Replace fan. Clear
Fault Code. |
| 821 |
Crankshaft encoder,
short circuit or open circuit. |
G450X |
Symptoms not openly
evident as bike starts and runs. |
The fault code was
still present. |
Cleared Fault Code.
Fault did not return. |
| 1592 |
Steppermotor, throttle
valve 2 defective |
G450X |
Symptoms not openly
evident as bike starts and runs. |
The fault code was
still present. |
Cleared Fault Code.
Fault did not return. |
